Search results for "Glass wool"
showing 4 items of 4 documents
Non-conventional Ce:YAG nanostructures via urea complexes
2019
AbstractCe:YAG nanostructures (Ce:YAG = Cerium in Yttrium Aluminium Garnet), easy to control and shape, have been prepared via templating approach using natural and synthetic materials (i.e. paper, cotton wool and glass wool) previously soaked with a gel-like metals precursor and then thermally treated to achieve the wished morphology. The final material, otherwise difficult to process, can be easily moulded, it is lightweight, portable and forms, at the nanoscale, homogeneous layers of interconnected but not agglomerated nanoparticles (15 ± 5 nm). Using the same synthetic route, called Urea-Glass-Route, but in absence of a template, extremely pure Ce:YAG nanoparticle (45 ± 5 nm) can be als…
Supercritical fluid extraction of pesticides
1989
The extraction behaviour of 10 μg samples of five pesticides and some related compounds from glass wool with supercritical CO2 has been investigated under several conditions (10 MPa, 20 MPa extraction pressure, 313 K, dry and water saturated CO2). The extraction fluid was decompressed over a line of little columns, filled with 3μ Si60 or RP18, and the amount of deposited material was analyzed by HPLC for each of these columns. Due to the progressive pressure/density reduction along the line, the solubility diminishes and hence the compounds are deposited according to their polarity/vapor pressure earlier or later on the line. Thus extraction and prefractionation of compounds of different po…
Photodegradation of Toluene, m-Xylene, and n-Butyl Acetate and Their Mixtures over TiO2 Catalyst on Glass Fibers
2012
The abatement of typical paint solvent compounds as individuals and in mixtures was carried out in an annular TiO2 supported reactor, for concentrations up to 900 mg C m–3. Two different fiberglass supports were compared, and the catalyst supported over a fiber mat showed better performance, with a lower pressure drop (>35% of reduction) and a slightly higher removal efficiency (about 2%) than that supported over glass wool. For every target compound in the whole range of relative humidity studied (4–75%), the photocatalytic activity increased with the air water content. The removal of the compounds in the binary and ternary mixtures was depressed, even >90% for toluene, compared with indiv…
Influence of cerium content and heat treatment on Ce:YAG@glass wool nanostructures
2019
The paper reports the influence of cerium content and heat treatment on composition, structural features and optical properties of nanostructures constituted by a layer of Ce:YAG nanoparticles on glass wool (Ce:YAG@GW). The Ce:YAG@GW nanostructures were obtained embedding the glass wool (GW) in a gel-like precursor and calcining at 800 and 900 °C. Gel-like precursor of urea glass route (UGR) method has been used to prepare both nanostructures and Ce:YAG nanoparticles prepared as references. Structural properties were investigated by using X-ray diffraction (XRD) and infrared spectroscopy (IR). Results showed that the composition of the final products strongly depends both on the cerium cont…